|
thatcutndude1 (November 30, 1999 at 12:00 am)
its a yzf 600 1997, 4 cylinder, some people telling me it might b a tip ova switch somewhere and i mite have to reset cause the guy i got it from did fall ova but it didnt hurt the motor, wateva they say im still lost.....ill try anything ritenow.....
ADPTraining (November 30, 1999 at 12:00 am)
@ADPTraining Cont: Assuming it's electronic ignition, there are a few things to check. Check available voltage ate the coil, should be 12.6V. If less, that you have a resistance at the power feed, relay, etc. Use a head light to test power feed. A headlight draws 6 Amps, which is the standard for most auto coils (assuming your system is 12 volts). Feed me more info and I'll do my best to help you out. Best of luck.
ADPTraining (November 30, 1999 at 12:00 am)
@thatcutndude1 Hello, I love to help, but this video is more for autos that motorcycles. However, the principle is the same. What kind of cycle is it, electronic ignition? Is it a 4 cycle engine, what size engine?
thatcutndude1 (November 30, 1999 at 12:00 am)
my motorcycle has lil or no spark wat can i try to get more spark i think i have a short somewhere but i checked my wireharness and still the same results, no or lil spark...i am so lost can u give any advice i can try please thank u....junior
TravisCadello (November 30, 1999 at 12:00 am)
dam thats crazy expensive.
scottsaz22 (November 30, 1999 at 12:00 am)
i had to change 6 of my ignition coils on my s500 so easy to change when one went out for the first time the engine would shake and i ended up needing one of these when i went to change it i could tell from the discoloration that i needed 6 since two were already changed (v8 engine) they were 104 dollars a peice...assholes,,,but now my car is smoooooooth!!!
cesarnono13 (November 30, 1999 at 12:00 am)
This video was GREAT!
ferratilis (November 30, 1999 at 12:00 am)
"A fault at either of this two circuits will create a misfire."
iluha18 (November 30, 1999 at 12:00 am)
what did he say at 0:47 secs?
iluha18 (November 30, 1999 at 12:00 am)
i did not get ti in the end, if there is no voltage in that ecm wire then its bad? i dont get it. |
